Archives

Virtual Serial Ports Emulator (VSPE) v0.938.4.846 32bit

FREE LICENSE FOR 32 BIT PLATFORM (X86) 🙂

VSPE is intended to help software engineers and developers to create/debug/test applications that use serial ports. It is able to create various virtual devices to transmit/receive data. Unlike regular serial ports, virtual devices have special capabilities: for example, the same device can be opened more than once by different applications, that can be useful in many cases. With VSPE you are able to share physical serial port data for several applications, expose serial port to local network (via TCP protocol), create virtual serial port device pairs and so on.

Yaesu FT817/857 Soft Jump Software by VK2IT V0.2

by Peter May, VK2IT, vk2it@tpg.com.au

This program uses undocumented CAT commands to read or update the EEPROM
in the Yaesu FT817, FT857, and FT897 Radios. The soft jumper settings are stored
in location 4 and 5 of the EEPROM. Power the radio off and on to activate
the new settings. If you do a reset of the radio, you will have to run
this program again to rewrite the values
The program assumes that the radio CAT rate is set to 38400 baud

Yaesu FT817/857 Soft Jump Software by VK2JCG

by Peter May, VK2JCG, vk2jcg@yahoo.com.au

This program uses undocumented CAT commands to read or update the EEPROM
in the Yaesu FT817 and FT897 Radios. The soft jumper settings are stored
in location 4 and 5 of the EEPROM. Power the radio off and on to activate
the new settings. If you do a reset of the radio, you will have to run
this program again to rewrite the values